During the cement production process, cement ball mill is one of the important equipment to preparing cement, improving the cement ball mill output,it also has the practical significance for cement enterprises to achieve high quality, high yield, and low consumption. So how does the cement mill achieve high quality and high yield?CHAENG will tell you as follows.

1. Reduce the feeding material size

In recent years, the cement feeding material attracted manyt attention for many cement companies, among the cement industry "more broken less grinding" point is gradually accepted. The original of 30mm material particle size changed into 3mm below, therefore increasing the mill yield.

2. Optimize the cement grinding process

At present, the cement production line usually using open circuit system, cement fineness is not easy to control, fluctuations. If the open circuit system change into closed circuit system, and install the efficient rotor separator and bag filter at same time that can improve the cement surface area, increase the strength of cement good results.

3. Control the moisture and temperature of feeding material

Ensure the feeding material integrated moisture control at 1.5%, which is the basic premise to guarantee the quality and cement mill high yield . Therefore, the cement enterprises need strictly control the mix the moisture and material production process when drying water, controlling the feeding material at suitable tempreture that to ensure good operation of cement mill.

4. Ensure the mill inside is well ventilated

In the daily production, the cement enterprises should fully understand the importance of ventilation in the cement ball mill, they can use strong ventilation, bag filter and other measures to ensure the mill inside smoothly ventilation. According to the actual production needs, under the equipment configuration allowing circumstance, appropriately add the ball, paragraph load, which has great benefit to improve the mill yield. In addition, due to the cement mill grinding body working environment is relatively poor that often with a variety of cement raw materials in direct contact, the wear is quite serious, therefore, the manufacture should pay attention to the grinding device damage.