The ball mill is also an indispensable equipment in the mine equipment. When it comes to difficult-to-break items, the ball mill will send its effect. The ball mill has a good grinding effect and a high operating rate. It is the first equipment in the selection of mineral processing. When using a ball mill, it is usually included (including ball mills, classifiers, lubrication systems, and feeders), so be sure to note the following:

Ball mill equipment in the ore dressing considerations:

The ball mill is also an indispensable equipment in the mine equipment. When it comes to difficult-to-break items, the ball mill will send its effect. The ball mill has a good grinding effect and a high operating rate. It is the first equipment in the selection of mineral processing. When using a ball mill, it is usually included (including ball mills, classifiers, lubrication systems, and feeders), so be sure to note the following:Fully check whether the equipment is installed properly, start each equipment with a certain interval, and start feeding the equipment after the equipment has started operating normally and steadily (if the oil pump works normally, start the ball mill again, and wait for the ball mill to run for 2 to 3 minutes before starting the feeding. It should be noted that the ball mill is parked for more than 4 hours. Before driving, it is usually necessary to carry out 2 or 3 turns of the disc to loosen the bonded sludge and medium. Normal stopping (planned parking) should be carried out under empty load, as far as possible the material in the equipment. Discharge net (such as the ball mill should be stopped 15~20min after the mine is stopped), to create conditions for the next drive.The mill running time should not be too long in the absence of feed, usually less than 20min, so as not to consume steel balls and damage Liner, this is still more important under normal maintenance. If you are a newcomer to the ball mill, please consult the manufacturer before use.