Chaeng(Great Wall Machinery) can undertake the 200-1500t/d activity lime production line EPC, including the the reach report, civil engineering, designing, equipment, installation and debugging ---“ turnkey” service with production capacity and standard achieved.

Active lime production line working principle in the following:

Qualified limestone stores in silos and be shipped through the pre-heater by the elevator into the silos which is on the top of the pre-heater. The pre-heater on the top of silos is consisted of top and bottom level meter controllers which control the feeding capacity. Then through the feed tube the limestones are distributed to the indoor compartment of the pre-heater.

The limestones in the pre-heater is heated to around 900 ℃ by the kiln flue gas of 1150℃. At this time, about 30% of the limestones have been decomposition. Then the limestones are put into the rotary kilns by the hydraulic stem. In the rotary kilns the limestone sinters and decomposes into CaO and CO2. Then the decomposed limestones go into the cooler and is cooled to about 100℃by the cold air and then is discharged. The 600℃hot air after heat exchange goes into the kiln and combusts with gas. The Exhaust gas blended with the cold wind go to the bag filter through the suction fan and then through the exhaust fan into the chimney.

The limestone out of the cooler enters into the lime storehouse through the vibrating feeder, chain bucket conveyor, bucket elevator and belt conveyor. Whether to carry out screening and other procedures depends on customer requirements.